User manual

Connecting Wireless Devices with the FRITZ!WLAN Repeater

3. Select “System / Operating Mode”.

4. Click the “Change Operating Mode” button.

5. Select the “LAN bridge” operating mode.

6. Click “Next” and follow the instructions.

7. Connect the web router to the FRITZ!WLAN Repeater with

a LAN cable.

7.4 Connecting Wireless Devices with the FRITZ!WLAN Repeater

When the “LAN Bridge” operating mode is enabled in the

FRITZ!WLAN Repeater you can establish wireless LAN connec-

tions to computers and other wireless devices in two ways:

• using the wireless LAN software of the computer or the

wireless device

• using WPS

– Start WPS by pressing the button on the

FRITZ!WLAN Repeater; see Button and LEDs on

page 7.

– The wireless device must support WPS and WPS must

be enabled in the wireless device.

– The SSID (radio network name) of the wireless access

point must be visible.

– If a MAC filter is enabled in the wireless device, enter

the MAC address of the FRITZ!WLAN Repeater in the

filter as an exception or disable the filter for connec-

tions established via WPS.

In the “WLAN Bridge” operating mode only the wireless ac-

cess point can be connected with the FRITZ!WLAN Repeater

via WPS.