User manual

2. IR remote control
 Use “1” ~”7” key to select video input port.
 Use “◄”, “►” key to select another video input port.
 Use ” ” key to power on/off MRM-701.
Support HDMI mode
Max resolution: UXGA(1600x1200@60), 1080p@60, 12-bit.
Support VGA mode
Analog Resolution Frequency(Hz)
VGA 640x480 60 / 72 / 75 / 85
VGA 720x400 70 / 85
SVGA 800x600 56 / 60 / 72 / 75 / 85
WVGA 848x480 60
XGA 1024x768 60 / 70 / 75 / 85
SXGA 1152x864 75
SXGA 1280x768 60RB/ 60 / 75 / 85
WXGA 1280x800 60
SXGA 1280x960 60 / 85
SXGA 1280x1024 60 / 75 / 85
WXGA 1360x768 60
SXGA+ 1400x1050 60RB / 75
WXGA+ 1440x900 60
SXGA+ 1440x1050 60
UXGA 1600x1200 60
WSXGA+ 1680x1050 60
1080p 1920x1080 60
WUXGA 1920x1200 60RB
720p 1280x720 60
Support YPbPr mode
Analog Resolution Frequency(Hz)
480i 720x480 60
576i 720x576 50
480p 720x480 60
576p 720x576 50
720p 1280x720 50 / 60
1080i 1920x1080 50 / 60
1080p 1920x1080 50 / 60
-3-
Support CVBS/ S-Video mode
Analog Resolution Frequency(Hz)
480i 720x480 60
576i 720x576 50
Matrix Application Software
Software Introduction
The 《AV Matrix》 Matrix control software applies to
different input/output matrixes.
Software Activation
Power on the computer: Implement the AV Matrix.msi to
activate installation screen as below, click “Next”. And
follow the instructions on screen to finish the installation.
Connect MRM-701 and PC
You must power off the MRM-701. Then, connect the
MRM-701’s RS-232 port to the PC’s RS-232 port.
Matrix Configuration
After finishing installation, click
to active
AV Matrix Application. In the “Options” screen, select the
connected PC Port number and Baud rate, and then click
“OK”.
-4-
Press the “Scan” and found the connected MRM-701 first.
Then use mouse cursor to select which input port to switch,
and press the left button
Communication Protocol/Control Command Code
Communication Protocol: Baud rate 9600bps, no odd or
even calibration bit address, 8bit transmission address,
1bit stop address. Please refer to the “Command list.pdf”
in the CD-ROM for more relative Command Code
information.
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
Trademarks:
All the companies, brand names, and product names
referred to this manual are the trademarks or
registered trademarks belonging to their respective
companies.
-5-