Manual

Distribution Amplifier (DA)—User Manual
39
7.3 LAN Web Configuration
Open the Browser on your PC, key in the default IP address: http://192.168.0.3 to login
the AV MATRIX Control configuration window. Once the default IP address is changed,
please use the changed IP to login.
The software controls signal connection between the corresponding input port and
output port as required. The LAN main configuration window is as below:
Figure 7-13 LAN Web Configuration Window
) The Distribution Amplifier (DA) is integrated HDMI switching equipment. You can only
key in the Output Channel No. into the Video field for configuration.
) The Distribution Amplifier (DA) device ID is based on the DIP of switcher located on
the rear panel. Beside, please adjust the DIPs to LAN and Master for the web control
device.
 Set: Click this button to set the connected combinations both output and input ports.
 OFF: Disable the entire output channels.
 Refresh: To refresh the values of the configuration window. Any changed settings
directly on the Distribution Amplifier (DA) will not respond to the AV Matrix operating
interface, you have to click the “Refresh” button to refresh the configuration window
so that showing the changed values.
 Load: Click this button to retrieve the previously saved settings.
 Scan: To search the device controlled by the LAN Web Configuration. When the
Console List content is empty, you can click the “Scan” to research and update the
Console List. If the connections of your Distribution Amplifier (DA) are over to 8 devices,
you can click “Previous” or “Next” to view console list by paging.