Manual

Distribution Amplifier (DA)—User Manual
27
7.1.3 Connect Distribution Amplifier and PC
You must power off the Distribution Amplifier (DA). Then, connect the RS-232 port to the
PC RS-232 port with the bundled communication cable. And make sure the DIPs on the
rear panel are set to Master and RS-232. (Refer to the previous section 6.6.1 RS-232)
7.2 Configuration
After finishing installation, click to active AV Matrix Application. In the “Options”
window, select the connected PC Port number and Baud rate, and then click “OK”.
Figure 7-2 AV Matrix Options Window
The software controls signal connection between the corresponding input port and
output port as required. The AV Matrix software application main window is shown as
below:
Figure 7-3《AV Matrix》Software Application Main Window