Manual

Distribution Amplifier (DA)—User Manual
10
5.2 Rear Panel
Figure 5-3 HDMI-E8 Rear Panel for 8 Output Jacks
HDMI-E8 supports 1 input jack (HDMI Type A) and up to 8 output jacks (RJ45) on the
rear panel, each female terminals form the signal input/output jacks. The HDMI-E8 signal
output terminal channels are numbered as OUT1~8 channels.
Figure 5-4 HDMI-E16 Rear Panel for 16 Output Jacks
The HDMI-E16 supports 1 input jack (HDMI Type A) and up to 16 output jacks (RJ45) on
the rear panel, each female terminals form the signal input/output jacks. The HDMI-E16
signal output terminal channels are numbered as OUT1~16 channels. The input terminal
channel supplies you to connect to different equipment including Blu-ray/DVD player,
graphics workstation, and number display. The output jacks allow you to connect to
extensible accessory devices for over long connections with terminals just like projectors,
video recorders, displays, multiplexers and so on.
 Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source. Refer to 6.4 Power Connection
.
 Power Switch: To switch power ON or OFF the Distribution Amplifier (DA).
 RS-232: Use a 9-pin RS-232 cable to connect both computer serial port (COM1 or
COM2) and Distribution Amplifier (DA) RS-232 communication port, refer to 6.6.1
RS-232. The computer then can be deployed to control the Distribution Amplifier (DA).
Refer to 7.1 Software Introduction for a software control or Appendix D RS-232
Communication Protocol for an individual configuration.
 RS-485: Connection ports allow you to connect/control more than one relative product
(ex. Matrix, DA and so on), refer to 6.6.2 RS-485.