User`s guide

1.4 HELP FEATURE
Use of HELP provides a quick reference
7
of commands. Included are Programming
Commands, Editing Commands,
Memory/Disk
Data Transfer Commands, Mag Tape Control
Commands, Editing, Print Commands, and
X-15 Programming Commands.
To access HELP, at any point in the
program, 'press the
F1 key. To return to
the program, press ESC.
1.5 SCROLLING
.
The GENESIS permits scrolling at a rate
of
10 lines per second through the cues
in memory in both forward and reverse
directions. Depressing the
F10 key will
initiate scrolling in the forward
direction and the cues will move from
bottom to top on the monitor.
Depressing the
F9 key will initiate
scrolling in the reverse direction and
the cues will move from top to bottom on
the monitor. This replaces the REPEAT
key not found on GENESIS.
Scrolling can also
be started in the
forward direction by depressing the
Q
(letter) key in a repeated manner.
Likewise, reverse scrolling is obtained
by depressing the Control key and then
pushing the
Q key. The message STANDBY '7