User`s guide

2.3.3 MAGNETIC TAPE CONTROL COMMANDS
/7
CEM (CLOCK EDIT MODE)
Allows the GENESIS to read Clock-trak or
SMPTE off magnetic tape and synchronize
the program in memory. If the tape data
stops, the program will stop
0.5 seconds
after the data stops. As soon as the
Clock-trak or SMPTE input begins again,
the system will execute a
GOT0 to be
ready for the next section.
CIM (CLOCK INPUT MODE)
This command will put the system into
,, CLOCK INPUT MODE. The Clock-trak or
SMPTE data on a tape does not resemble
normal cues on a data tape so the AVL
GENESIS will ignore Clock-trak or SMPTE
data unless you are in either CLOCK
INPUT or CLOCK EDIT mode. When the
system is in either of the two modes
(CIM, CEM), it will accept only SMPTE or
CLOCK-TRAK data as a valid input. The
Clock-trak or SMPTE data coming into the
system starts and stops a program stored
in the memory of the AVL GENESIS at the
precise times you designate and normal
cue data is sent out of the system.
The main difference between CLOCK INPUT
and CLOCK EDIT modes
is,that in CLOCK
INPUT mode the system will continue to