User`s guide

-
When PROCALL encounters a time cue while
in the RUN mode, it will cause' the
program to stop.
PROCALL will then wait
until the clock equals the value of the
time cue and then put the program into
the RUN mode again.
TX (TIME X)
TX is used to mark the beginning of a
timed (RUN) sequence using the
Clock-
trak or SMPTE. The X value is resolved
when you press the
F10 (CUE) key.
W.05 thru
W10 (WAIT TIMES)
T
Waits are computer-generated timing
links that
.allow you to time out action
sequences precisely. These times are
entered into the program in the form of
wait cues ranging from
.05 seconds up to
10 seconds. If a wait time longer than
10 seconds is desired, you may use
consecutive wait cues to achieve the
desired wait time.
NOTE: Because of the convenience
of using Clock-trak or SMPTE, we
strongly suggest that you use it
instead of WAIT commands for times
in excess of
2.0 seconds.