User`s guide

CHAPTER 2
GENESIS PROCALL-5 COMMANDS
2.1 GENERAL
This chapter lists and describes the
commands valid under
AVL's Genesis
PROCALL-5 software.
2.2 PROGRAMMING COMMANDS
The subparagraphs that follow describe
the Programming Commands used with AVL
Genesis PROCALL-5.
-,
2.2.1 COMMANDS ENTERED UNDER THE CODE
HEADING
CT (CUT)
A cut turns the lamp ON or OFF quickly.
If the lamp
is already ON, this will
turn the lamp OFF and initiate a tray
advance. If the lamp is OFF, it will
then be turned ON. If you wish to cross
from one visual to another quickly, a
CUT will turn the ON lamp OFF and the
OFF lamp ON, and the projector with the
down-going lamp will perform
a tray
advance.
A cut employs the after burner
effect as described in the note below.