User`s guide

1.9 MAG TAPE BYPASS
,1
This is the normal default mode of the
GENESIS. Whenever Genesis PROCALL-5 is
loaded into the GENESIS it will
automatically come up in Mag Tape Bypass
and a message announcing this will be
displayed on the screen.
If you decide to load a program which
was saved on tape, the GENESIS will
automatically switch modes and load the
program into memory and then when the
program is loaded it will revert to the
Mag Tape Bypass mode.
In a similar manner the GENESIS will
switch from Mag Tape Bypass to Clock
Edit Mode automatically upon receipt of
Clock Trak. When
the Clock-Trak input
stops it will remain in CEM mode until
it receives data at the input, and at
that point switch back to Mag Tape
Bypass. If the GENESIS has been set up
for a Mag Tape Load (SHOW PRO
V
compatible), touching any of the keys
after the load is completed will return
the GENESIS to the Mag Tape Bypass mode.
NOTE: The previous Control Command
entries of MTB (Mag Tape Bypass)
and MTN (Mag Tape Normal) are no
longer necessary.