User`s guide

WX (WAIT X)
-\\
This cue is used when the proper timing
of a sequence has not been determined
before programming. The
WX cue is
resolved to the nearest .05 second when
you are operating at
20 cues per second
and to the nearest .1 second when you
are operating at
10 cues per second.
The WAIT
X is resolved by pressing the
F10 (CUE) key during the running of the
particular section.
5.2.2 COMMANDS ENTERED UNDER THE SCREEN
HEADING
n
R (RUN)
RUN is used in the screen area of the
DISPLAY LINE to designate one of the
following:
1. To mark the beginning of a
REPEAT sequence.
2. To initiate a RUN sequence.
3. As a reference point.
S (STOP)
A stop is used in the screen area of the
display line to designate one of the
A,
following: