User`s guide

is essentially a null cue, that is,
nothing goes out the mag tape channel
when it is executed.
WHEN A MAG TAPE
r7
SAVE (MSV) operation is performed the y
time cues are recorded on the tape. A
time cue takes less than .O1 seconds to
execute.
When PROCALL-X encounters
a time cue
while in the run mode, it will cause the
program to stop. PROCALL-X will then
wait until the clock equals the value of
the time cue and then put the program
into the
RUN mode again.
W.05 thru
W10 (WAIT TIMES)
Waits are computer-generated timing
links that allow you to time out action
sequences precisely. These times are
entered into the program in the form of
wait cues ranging from
.05 seconds up to
10 seconds. If a wait time longer than
10 seconds is desired, you may use
consecutive wait cues to achieve the
desired wait time.
NOTE: Because of the convenience
of using Clock-trak, we strongly
suggest that you use
it instead of
WAIT commands for times in excess
of
1.5.