User`s guide

NOTE: A projector lamp does not
turn on or off instantly with the
application or removal of power.
The lamp actually requires a
fraction of a second to heat up or
cool down. This is called the
"thermal lag" of the lamp, and the
lag is different for turning the
lamp on than
it is for turning the
lamp off. All AVL computerized
dissolve controls automatically
compensate for this effect.
Cuts and Alternates employ an
"After-burner Effect" which allows
the lamp to reach its full
intensity. Because of the time
involved due to the lamp lag, the
after burner does not allow the
lamp to flash on and off at
20
cues per second. Therefore, the
Fast Alternate was created to
defeat the after burner and to
allow solo flashing and movement
of visuals at
20 cues/second.
SC (SOFT CUT)
A soft cut is a compromise between
a cut
and a one second dissolve. The
projector with a down lamp will do a
tray advance.