User`s guide

/7
is encountered while the clock is free
running, the clock will stop.
THIRD LINE
This is the CONTROL COMMAND field and
its features are discussed in Chapter
5.
THE TPO CONTROL COMMAND
TPO (tray position offset) permits you
to set the starting tray position. Once
you have saved a program with a
particular starting tray position the
new position is retained. Anytime you
load that file the starting position
will be reset to that value. Note that
?
this does not send cues to to the
equipment attached to the system. It
assumes that you actually started with
your trays in the offset position.
This command removes the tray designa-
tion and replaces that information with
a DOVE
X number and A,B,C projector
assignments, this allows a rapid
examination of the independent and
it's
corresponding projector assignment.