User`s guide

The space to the right of MODE selection
is reserved for incoming data display.
When the system receives cue information
from either magnetic tape or another AVL
programmer, this line will display the
word AMP if the data is of sufficient
amplitude. MT POOR is displayed if the
incoming data has some distortion in it,
but the system will still be able to
decode the cue. If the data is so
distorted as to be unreadable by the
system, MT BAD and the cue number of the
distorted cue will be displayed. When
no data is received by the system the
display will remain blank. If only
POSI-TRAK information is being received
by the system the display will show the
word POSI-TRAK.
CLOCK DISPLAY
The Clock Display is located on the
right hand side of the screen on the
second line. This clock acts as a free
running timer as well as a display for
Clock-trak from magnetic tape in either
CLOCK EDIT or CLOCK INPUT mode. The
clock will begin to
run anytime the CUE
(F10) key is depressed and a TIME or
TIME
X cue is executed. It will
continue to run until a STOP is
encountered or you push the ESC key.
Additionally,
if the end of cue space
(no clock-track data is being received)