User`s guide

NOTE: If you do not want to name
the program, press RETURN and the
program will be named DEMO 1.
However, if you save the program
it will write over
any DEMO 1
program already existing on the
disk.
A line-by-line description of the
programming panel follows.
2.2.1 THE COMMAND AREA
TOP
LINE
This line contains the program name and
the name of the operator. The space
provided for the program title is
8
characters long and the operator name
space is 25 characters long. If you
skip over the "HELLO" sequence using the
RETURN key, the program title will
default to DEMO 1, and the operator name
will be blank.
SECOND LINE
This line contains the Programming MODE
selection. The possible choices are MTB
(Magnetic Tape Bypass), the default
mode, CEM (Clock Edit Mode), CIM (Clock
Input Mode), COM (Clock Output Mode),
MSV (Mag-Tape Save), MLD (Mag-Tape
,, Load), and VER (Verify-MSV only).