User manual

Other devices on Network:

In some cases, you may have a large number of devices from various manufactures that are all on the same

network. ScreenCrop will detect all the devices that are set to the Network Mask ScreenCrop is on. If

ScreenCrop does not support a device, then the status button will be grayed-out and non-selectable. If

you click Change IP, the following error message will also appear.

Figure A-3 Device That Is Not Supported by ScreenCrop Utility (Error Message)

Method 2: Change the IP Address of the Controlling Computer

For Windows XP

Step 1. Click Start, and then right-click My Network Places. Click Properties.

Step 2. When the next screen appears, right-click Local Area Connection icon, then click Properties.

Step 3. Check (to highlight) Internet Protocol (TCP/IP), then click Properties.

Step 4. Click the radio button to select Use the following IP address:, then enter the IP address:

210 . 100 . 100 . x (where x is any value from 1 – 253), and Subnet mask: 255 . 255 . 255 . 0.

Step 5. Finally, click OK to exit.

For Windows 7

Step 1. Click the Start menu and type in Network and Sharing Center.

Step 2. Click Change Adapter Settings located on the left.

Step 3. Right-click the Local Area Connection that the Pacific is connected to, then select Properties.

Step 4. Check Internet Protocol Version 4 (TCP/IPv4), then click Properties.

Step 5. Click the radio button to select Use the following IP address:, and then enter the IP address:

210 . 100 . 100 . x (where x is any value from 1 – 253), and Subnet mask: 255 . 255 . 255 . 0.

Step 6. Again, click OK to exit.