User manual

17
2.2.4 Cropping Feature
ScreenCrop utility sets 2 instances of “area of interest.” The associate contents can then be transmitted
to the intended audiences. To crop areas of interest, perform the following steps.
Figure 2-7 Cropping a Defined Area of Interest
Step 1. Click the Crop button and use the cursor to select an area to crop. Upon releasing the left
mouse button, 4 green cropping corners will display the selected area.
 A floating 5× magnifying window will display any nearby graphics at 5x and other
relevant cursor information (e.g., position and RGB value).
Figure 2-8 Magnified Floating Window Showing Cursor and RGB Value
 Click on and drag any of the 4 green cropping corners to enlarge/reduce the area just
selected. You may also use the keyboard’s top/left/right/down buttons to fine-tune the
scope of the area to be cropped without using the mouse button.
 For additional fine tuning, you may manually enter the values of the Left/Top/Width/
Height and click the Set button. This will modify the scope of area to be cropped at
pixel-level accuracy.