User manual

9
Image
Adjustment
Status
On: selects the output signal
 Source: auto-detects CVBS, SDI, YPbPr, VGA, DVI, HDMI in that order
 VGA Adjustment: this feature was designed to re-adjust analog VGA
signal in the case of misalignment or a color-off due to long cabling
situations.
Note: Only available when the signal is VGA.
 DEFAULT
 HSTART (horizontal starting position)
 VSTART (vertical starting position)
 HACTIVE (horizontal “active area” / width)
 HTOTAL (horizontal total) ****(refer to figure 2-4 below)
Make sure that the values of HSTART plus HACTIVE do not
exceed HTOTAL.
 VACTIVE (vertical “active area” / height)
 VTOTAL: (vertical total) ****(refer to figure 2-4 below)
Make sure that the values of VSTART plus VACTIVE do not
exceed VTOTAL.
 REDGAIN
 GREENGAIN
 BLUEGAIN
 AUTO ADJUST (performs automatic alignment of VGA image
inside the window)
 AUTO GAIN (performs automatic gain adjustment by correcting the
color values)
 CVBS/YPbPr Adjustment: feature is for re-adjusting CVBS or YPbPr
signal in the case of misalignment or a color-off due to long cabling
situations.
Note: Only available when the signal is CVBS or YPbPr.
 DEFAULT
 HSTART (horizontal starting position)
 VSTART (vertical starting position)
 HACTIVE (horizontal active area or width)
 H TOTAL (horizontal total) ****(refer figure 2-4 below)
Make sure that the values of H START plus H ACTIVE do not
exceed H TOTAL.
 VACTIVE (vertical active area or height)
 V TOTAL: (vertical total) ****(refer figure 2-4 below)
This value is based on the values of VSTART plus VACTIVE.
(Note: must not exceed the pre-determined value for V Total).
Make sure that the values of VSTART plus VACTIVE do not
exceed VTOTAL.
 Image Parameter:
 BRIGHTNESS
 CONTRAST
 SATURATION (only available when signal is CVBS, or YPbPr, or
SDI, or HDMI)
 HUE (only available for CVBS, or YPbPr, or SDI, or HDMI signal)
 SHARPNESS
 DEFAULT
Off: disables the image adjustment feature.
Exit
Exits the image adjustment setup menu.
Table 2-4 Image Adjustment