User manual

8
2.1.2 Navigating the Main Menu
1. Press the button from the default initial screen to enter the main menu.
2. Use the buttons on the front panel to navigate: ( / / )
3. There are a number of tables below, each detailing an item on the main menu (Input Port,
Output… etc.). Each table lists the choices that can be made within each item.
Input Port
Autoscan
On: enables the automatic detection feature.
Off: selects the signal manually.
 Source:
 HDMI
 DVI
 VGA
 YPbPr
 SDI
DVI Loop Out
On: enables the DVI-D loop out feature.
Off: disables the DVI-D loop out feature.
Exit
Exits the input signal setup menu.
Table 2-1 Input Port
DVI-D loop out does not support analog source signals; VGA or YPbPr (through VGA or YPbPr to DVI
adapter).
Make sure to select the correct signal type based on the actual connected input signal to Pacific C-HSS in
order to avoid image display problems (e.g., noise, flicker, etc.).
Output
SDI
On: selects the output signal.
 1080p @ 23.98, 24, 25, 29.97, 30, 50, 59.94, 60 (Hz)
 1080i @ 23.98 PsF, 24 PsF, 50, 59.94, 60 (Hz)
 720p @ 23.98, 24, 25, 29.97, 30, 50, 59.94, 60 (Hz)
 SD_625 (576i @ 50 Hz)
 SD_525 (487i @ 59.94 Hz)
Off: disables the SDI out feature.
Exit
Exits the output signal setup menu.
Table 2-2 Output
Map Structure
Status
Selects the desired “sampling structure/pixel depth” based on output
signal’s “image format” and “frame/field rate.”
 YCbCr422
 YCbCr444
 RGB444
Exit
Exits the map structure setup menu.
Table 2-3 Map Structure
1. Embedded audio is not available under the YCbCr444 and RGB444 output formats.
2. Map structure is locked at YCbCr422 when output resolution is at SD_525, SD_625, 1080p@50,
1080p@59.94, 1080p@60 (Hz).