User manual

7
2. System Configuration
This chapter discusses the process of using the LCD panel to set up the Pacific C-HSS, as well as the
procedure for using the Avitech ScreenCrop utility.
2.1 Using the LCD Panel
Consisting of 3 buttons, the LCD panel allows for complete control of the Pacific C-HSS. This control
includes input/output signal adjustment, video crop, keying/overlay, aspect ratio adjustments and an
operational status report.
Go to previous selection (up arrow button)
Go to next selection (down arrow button)
Enter the next level of a menu, or select the currently highlighted item.
Figure 2-1 LCD Panel: Busy State
1. When the busy state “PLEASE WAIT . . . .” message is displayed on the LCD panel (see sample
screen above), DO NOT disconnect or connect any signal cables as an error may occur.
2. Also, DO NOT change any of the incoming signal’s display resolutions while the Pacific C-HSS is in the
busy state.
2.1.1 Welcome Screen
Upon starting up the LCD panel, the welcome screen is shown for about 15 seconds.
Figure 2-2 LCD Panel: Welcome Screen
Then the following default screen is displayed.
Figure 2-3 LCD Panel: Default Initial Screen
This screen displays the unit’s default settings.
1. First line (video): AUTOmatically selects the input signal in the following order (firstly CVBS, SDI,
YPbPr, VGA, DVI, and lastly HDMI) when it detects more than one signal type.
Then, the SDI receives the output at 1080P @ 60Hz.
2. Second line (audio): The default audio source is set to HDMI. The audio feature allows the selection of
audio signal source (HDMI, SDI, or LINE IN). The audio delay feature shows BYPASSed when there is
no audio delay.
Settings made through the LCD panel will be saved automatically upon turning off the Pacific.