User manual

14
AFD Detect
Status
On: AFD (Active Format Description) solves a problem in the transition to
widescreen 16:9 displays from conventional 4:3 display devices.
 Active area signaling allows the display device to process the
incoming signal, making the most accurate picture with the highest
resolution possible. Aspect ratio signaling allows the display device
to produce the best image possible.
Off: Disables the AFD detect feature.
Exit
Exits the AFD detect setup menu.
Table 2-7 AFD Detect
1. When the “AFD DETECT” feature is set “ON,” the “CROP IMAGE” function will be automatically
disabled.
2. When the “AFD DETECT” feature is set “ON” and AFD is present in the input signal, the “ASPECT
RATIO” function (described in the previous item) will be automatically disabled.
3. When the “AFD DETECT” feature is set “ON” but AFD is not present in the input signal, this function is
invalid and the “ASPECT RATIO” function (described in the previous item) will not be affected.
Note: AFD (Active Format Description) has been added to many digital interfaces for the purpose of
identifying the video payload*. AFD solves a problem in the transition to widescreen 16:9 displays from
conventional 4:3 display devices. Active area signaling allows the display device to process the incoming
signal, making the most accurate picture with the highest resolution possible.
* Video payload is defined as the picture carried by a digital interface and comprised of a matrix of horizontal
and vertical pixels. The matrix usually comprises of a multiplex of luminance and color components.
Color Correct(ion)
Status
On: enables the color correction feature.
Off: disables the color correction feature.
Exit
Exits the color correction setup menu.
Table 2-8 Color Correction
1. This function is applicable for 1080p input signal only.
2. When the Pacific C-HSS is connected to the Pacific C-SHS, make sure that the COLOR CORRECT
function is enabled (set ON) on the Pacific C-HSS and the Pacific C-SHS’s is disabled (set OFF) to
allow the correct embedded color signal to pass through.
Headphones
Status
Enable: listen to the audio output via headphones.
 SOURCE: select from the available 4 source channels.
 CH1, CH2, CH3, CH4
 MIX MODE: select the left/right/both channels.
 LCH, RCH, R/L
 DELAY: sets the audio delay time.
 0 to 170ms, sample rate at 48kHz.
 BYPASS: this means there is no audio delay.
 VOLUME: adjusts the volume.
 MUTE up to 127 (level).
Mute: disables the audio output via headphone feature.
Exit
Exits the headphone setup menu.
Table 2-9 Headphones