User manual

7
2. System Configuration
This chapter discusses the process of using LCD panel to set up the Avitech Pacific C-SHS.
2.1 Using the LCD Panel
The LCD panel allows for complete control over the Pacific C-SHS, including output signal adjustment,
safe area graticules, audio meters, audio alarm, video alarm, customizable labels, image cropping,
aspect ratio adjustment, and an operational status report. The LCD module consists of 3 buttons:
Go to the previous selection (up arrow button)
Go to the next selection (down arrow button)
Enter the next level of a menu, or select the currently highlighted item when no further level exists.
Figure 2-1 LCD Panel: Busy State
1. When the “PLEASE WAIT . . . .” message is displayed on the LCD panel (see sample screen
above), DO NOT disconnect or connect any signal cables as an error may occur.
2. Also, DO NOT change any of the incoming signal’s display resolutions while the Pacific C-HSS is in
this busy state.
2.1.1 Welcome Screen
Upon starting up the LCD panel, the welcome screen pictured below is shown for about 15 seconds.
Figure 2-2 LCD Panel: Welcome Screen
The following default initial screen is subsequently displayed.
Figure 2-3 LCD Panel: Default Initial Screen
This screen displays the unit’s default settings.
1. First line (video): Displays the current video output settings.
2. Second line (audio): Displays the audio status, whether the delay feature is:
 BYPASSed (OFF – no audio delay).
 DELAY (ON – audio delay).
Settings made in the LCD panel will be saved automatically upon turning off the Pacific.