User Guide

RA2 Owner's Manual Rev. B - 0499

User-Programmable Features

All system and remote control programmable features are accomplished by

turning the ignition key "ON" (or starting the engine) and flicking the valet

switch on and off a preset number of times.

The system also allows you to add new remote controls in one step, delete lost

or stolen remote controls or rearrange the factory preset remote control

functions.

1. Remove the system from Protected Valet Mode. Programming cannot be

accessed while the system is in Protected Valet Mode indicated by the LED

on solid red.

2. Select the feature you wish to program from the "Programming Table for

System Features" below or the "Programming Table for Remote Controls"

on page 9. Note the number of beeps associated with that feature.

3. Turn the ignition key to the "ON" position.

4. Within 10 seconds, begin flicking the valet switch on and off. The siren

will beep once each time you flick the switch on then off.

5. Continue flicking the switch on and off, counting the number of beeps.

NOTE: Stop when you reach the number of beeps as so ci ated with your

cho sen fea ture.

6. Follow the "Secondary Action." You will hear a number of beeps to

confirm that you have changed the setting of that feature.

7. Turn the ignition key to the "OFF" position.

8. Repeat steps 1-7 for any other feature you wish to program.

Pro gram ming Ta ble for Sys tem Fea tures

Fea ture

Fac tory

Set ting

# of

Beeps

Sec on dary Action

Ignition Controlled

Door Lock/Unlock

ON 4