AviStart 6000 Owner's Manual
I WARNING I ! Always exercise caution and common sense when operating your AviStart system. ! This product is intended for vehicles with fuel-injection and automatic transmissions only. NEVER attempt to remote start a vehicle with a manual (stick shift) transmission. Serious injury may occur with improper use. ! NEVER attempt to remote start the engine while anyone (including pets) is in the vehicle.
Table of Contents AviStart 6000 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Lifetime Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Remote Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Stealth Coding Technology. . . . . . . . . . . . . . . . . . . . . . . 3 Electronic Scan Prevention (ESP). . . . . . . . . . . . . . . . . . . . . 3 Instant Remote Control Code Deletion. . . . . . . . . . . . . . . . . . 3 One-Step Remote Control Code Learning . .
AviStart 6000 Congratulations! You have just purchased the AviStart 6000, a remote engine starter and security system manufactured by Avital Technologies, Inc. You are about to experience the convenience and luxury of being able to start your vehicle engine from the comfort of your home, office, department store or other remote location. To benefit fully from the capabilities of your AviStart system, we encourage you to read the Owner’s Manual thoroughly before using the system.
Stealth Coding Technology Stealth Coding technology offers the most advanced protection available against "code-grabbing" devices which thieves may use to record the digital code transmitted by your remote control. When you leave the area, thieves can then play back the code to unlock the doors and deactivate your system. Avital's remote controls with Stealth Coding randomly change the code every time you use them, and your system will not respond if any code is retransmitted.
Operating Your AviStart To Arm The System The alarm can be programmed for active or passive arming. Active arming means the alarm can only be armed by the remote control. Passive arming means if you forget to arm the alarm with the remote control, the alarm will automatically arm itself 30 seconds after the doors have been closed and the interior lights have turned off. )See the "Programming Table for System Features" on page 14.) Active Arming Press the remote ARM/DISARM button for 1-2 seconds.
User-Programmable Long-Term Silent Arm/Disarm This feature allows you to completely disable the arm/disarm siren chirps until you decide to restore them. (See the "Programming Table for System Features" on page 14.) Remote Panic with Safety Locks In a threatening situation, you can activate Remote Panic with Safety Locks. When activated, the siren will sound and the parking lights will flash. If you are inside your vehicle and the ignition key is "ON," the doors will lock.
Protected Valet Mode You should place your system in Protected Valet Mode whenever your vehicle is being serviced by mechanics, car wash personnel or driven by valet parking attendants. While in the Protected Valet Mode, all remote starter and alarm functions are bypassed to prevent unauthorized or accidental operation. If a remote start is attempted, the parking lights will flash 4 times and the vehicle will not start.
Remote-Controlled Trunk Release Capability If you have the optional Trunk Release installed, simply press the remote control TRUNK button for 1-2 seconds to activate your vehicle electronic trunk release. The trunk will "pop" open (may require an optional relay). Remote-Controlled Accessory Output This output allows you to add an optional remote-controlled accessory to your system such as a window roll-up, garage door opener or fuel door release.
Alarm State Memory If your vehicle battery is disconnected and later reconnected, the system will automatically return to its last state before power was removed, whether it was armed, disarmed or in Protected Valet Mode. For example, if a mechanic disconnects the battery while the alarm is disarmed or in Protected Valet Mode, he won't trigger the alarm when he reconnects the battery.
Remote Engine Start - Safety and Counter-Theft Be sure to read the "WARNING" bulletin on the inside cover of this manual before attempting to operate remote start. I CAUTION: Automatic Safety and Counter-Theft Features Before remote starting your engine, the AviStart system will automatically perform a safety check to ensure the following conditions have been met: • Brake pedal is not depressed. • Engine and ignition are turned "OFF." • Hood is closed.
To Remote Start the Engine 1. Press the remote control START button for 1-2 seconds, 10-15 minutes before you enter your vehicle (this will allow the climate control time to heat or cool the interior.) The parking lights will flash 2 times, the engine will start and the parking lights will remain on as a visual indication that the engine is running. Five seconds after the engine starts, the doors will automatically lock.
User-Programmable Temperature-Controlled Starting Do not activate Temperature-Controlled Starting while the vehicle is in an enclosed area. I CAUTION: The AviStart system can be programmed to automatically start the vehicle engine whenever the temperature inside the vehicle reaches or drops below the preprogrammed temperature level. The AviStart will monitor the air temperature every 2.5 hours and will only start the engine during extreme cold temperatures. There are three temperature levels to choose from.
Pit Stop Mode Do not leave passengers or pets in the vehicle while the system is in Pit Stop Mode. I CAUTION: The Pit Stop Mode allows you to park the vehicle for short-term stops, remove the ignition key and leave the engine running. To Activate 1. While the vehicle engine is running with the ignition key turned "ON," press the remote control START button for 1-2 seconds. The parking lights will flash 2 times and stay on. (Make sure the vehicle is in "Park" and the parking brake is set.) 2.
User-Programmable Features All AviStart system and remote control programmable features are accomplished by turning the ignition key "ON" (or starting the engine) and flicking the valet switch on and off a preset number of times. The AviStart also allows you to add new remote controls in one step, delete lost or stolen remote controls or rearrange the factory preset remote control functions. 1. Remove the system from Protected Valet Mode.
Programming Table for System Features Factory No. of Setting Chirps Feature Secondary Action Active/Passive Arming Passive 4 Wait 3 seconds, the siren will chirp once for active, twice for passive. Passive Door Lock OFF 5 Wait 3 seconds, the siren will chirp once for OFF, twice for ON. Passive Arming Chirp/Light Flash Confirmation ON 6 Wait 3 seconds, the siren will chirp once for OFF, twice for ON.
Programming Table for Remote Controls Feature Factory Setting No. of Chirps Secondary Action Arm/Disarm ARM/DISARM button 20 Press ARM/DISARM button, the siren will chirp 1 time. Trunk Release Output TRUNK button 21 Press TRUNK button, the siren will chirp 2 times. Remote Start START button 22 Press START button, the siren will chirp 4 times. Silent Arm/Disarm SILENT button 23 Press SILENT button, the siren will chirp 3 times.
AviStart 6000 Owner's Manual
AviStart 6000 Owner's Manual
AviStart 6000 Owner's Manual
