User manual
•
Update timeout:
Enter the number of seconds after which an unsuccessful attempt to connect to the
server is aborted. Take into account the performance of your server. The minimum
value is 60 seconds. We recommend a value of 60 to 120 seconds.
•
Allow multiple concurrent calls:
Sets that the scan engine can process several e-mails at the same time. The
specific number of calls is set under Basic Configuration - AntiVir Server -
Properties - General tab: Number of threads. Also refer to Settings for an
Individual Avira AntiVir Exchange Server .
The Return Code Settings tab can be used to edit the pre-configured return codes. The
meaning of each code is to be found under Details - Comments.
The Jobs tab lists the jobs that use the scan engine.
Attention: Please do not use this tab for updating Avira AntiVir Exchange.
AntiVir powered by Avira
The AntiVir Engine is included in the installation package and is enabled by default.
Default parameters:
- /decomp (decompress PKLite and LZExe archives)
- /verbosescan (scan complete file)
Alternative parameter:
- /paranoid (interpret warning from heuristic analysis as virus)
If you are using a proxy server, specify the savapi.ini file for online updates in the
Setup. To change the file at a later stage proceed as follows:
1. Stop the SAVAPI service.
2. Go to the folder Avira\ AntiVir Exchange\Engine\.
3. Open the savapi.ini file with Notepad.
4. Set the following parameters:
Use proxy server for updates If this value is enabled (1), the engine tries to
download the updates through the specified proxy.
By default, no proxy server is used. Example:
ProxyEnabled=0 (=not enabled).
Proxy server address Use this parameter to enter the full name or IP
address of the proxy server used for the update.
This value is used only when “ProxyEnabled” is
enabled. Example: ProxyUrl=proxy.mydomain.de
Proxy port address The port specified here is used for updates through
the proxy server. This value is used only when
“ProxyEnabled” is enabled. Specify the port number
of the proxy server in this parameter. Example:
ProxyPort=3128
User name for proxy server (proxy authentication) Use this parameter to enter the user name under
which the update service logs on to the proxy
server. This value is used only when
“ProxyEnabled” is enabled. Example:
ProxyUserName=fmaier
Avira AntiVir Exchange 7
77