User Guide

IP POWER 1U USER MANUAL
4. Hardware & Software installation
Before you star to use IP Power 9258-1U, please follow the steps below
 Check the package to make sure the contents is complete.
 Prepare one Ethernet HUB or Router
 Check the voltage of the power supply to make sure it is AC 110-240 volt
 Please confirm the specification of your power cable.
* for 220-250V, please use power cable at MAX 10A for each 4outlet.
* for 100-120V, please use power cable at MAX 15A for each 4outlet..
Hardware installation
1 Connect the IP Power to HUB through network wire.
2 Connect the HUB or Router to the internet (may through ADSL/XDSL modem).
3 Connect the power adapter to the IP Power 9258-1U.
4 Connect the power adapters of under control electric equipment to corresponding
out port of IP Power 9258-1U.
Turn on your computer and the power adapter of IP Power 9258-1U
* For 220-250V, please use power wire can support 10A current..
Max. output current: ( total of each four outlets ) 10A , ( each outlet ) 6A.
• for 100-120V, please use power wire can support 15A current..
Max. output current: (total of each four outlets ) 15A , (each outlet ) 6A
Software installation
Having connected the power supply and network wire with RJ45 port to the IP Power 9258-1U, please install
the software by following the steps below:
1. Start your computer, put the installation disc in the CDROM, then find the file named “ ipedit.exe” in
the installation disc.
2. Save the exe file to your HD or desktop
3. Start the initial setting process following the construction in next section.
- 8 -