User Guide

IP POWER 1U USER MANUAL
NOTICE:
1) IP address format : xxx.xxx.xxx.xxx: yyyyy. yyyy means the port number,
Ranging from 1 to 32767.
2) Subnet Mask: from 0 to 254 ( xxx.xxx.xxx.0 ~ xxx.xxx.xxx.254 )
3) If DHCP is disabled, user must set the TCP Port and default Gateway .If DHCP is
enabled, then the TCP port will be preset to 80( xxx.xxx.xxx.xxx: 80 ) and the
default gateway will be set by the DHCP server, too..
4) If the TCP port you set is not 80, your should type in the whole IP address and port in
IE or Netscape, such as
http://xxx.xxx.xxx.xxx:yyyyy , or you can use the ipedit.exe
to login into the virtual IP of IP Power 9258-1U.
2. EMAIL SETTINGS:
When you finished the e-mail settings, you can set to let IP Power 9258-1U send its IP address automatically.
For example:
* Mail Server: abc.com
* Pop3Servcer : cdef.com
* Password : XXXXXXXX
* Sender: [e-mail]
* Receiver 1:
[e-mail]
* Receiver 2: [e-mail]
* Receiver 3:
* Subject: IP Power 9258-1U IP address
* MailBody : Hello
1.) Mail Server : the server sends e-mail out.
Please make sure the server is an available mail server.
2.) Pop3Server : the server receive IP address ( in Internet WAN ) from your ISP
for sending Internet IP address by E-mail when IP Power 9258-1U in Internet.
To receive IP address in WAN , please fill your ISP e-mail receive server.
- 16 -