User Guide

IP POWER 1U USER MANUAL
IP Power 9258-1U can control 8 outputs individually at the same time. User can choose power on or power off
with an electrical outlet . User may fill in the corresponding columns with the delay time you wish in seconds,
then choose the action after delay to be on or off.
Power Supply State Query
Click the “ Set Power” button on the left, the page will be refreshed. The state of each electric outlet will be
displayed in column control.
System Settings of IP Power 9258-1U
User can set the password, IP address, e-mail address, timer setting, online firmware update, and the time of
IP Power 9258-1U through the system settings.
1. Setting the IP address for IP Power 9258-1U:
Click the “ Setup “ button on the left side; fill in the proper IP address, Subnet Mask, Default Gateway, DNS. If
you choose to use DHCP, please make sure that your network support DHCP service so theIP Power
9258-1U will search and gain an IP address automatically when it start. You can also control the Beeper
sound .
- 14 -