User Guide

IP POWER 1U USER MANUAL
3. IF user can not enter the control web page, please set the IP address of IP Power 9258-1U and your
computer in the same subnet. User can obtain the computer’s IP address, subnet mask, and default
gateway through the following method.
start  run type in “cmd” then open the MS –DOS window, now type in
“ipconfig”
The last number of the IP address (default is 100) can be any number between 1~254, but cannot be the same
with that of the computer’s. If you want to use it at home, you can enter the web page by typing in the IP, the IE,
or using ipedit.exe program.
*Same subnet : means the first three parts of the IP address must be the same, such as XXX.XXX.X.abc. For
example, 192.168.1.100 and 192.168.1.123 are in the same subnet.
5 .The default username and password of IP Power 9258-1U are:
Username: admin
Password: 12345678
Setting of software shut down controlled PC/ Server
9258 can safety turn off the PC/Server through Network then cut off the power of PC /Server . By this way you
can remote shut down PC/ Server which is connect with IP Power 9258 by normal Windows shut down
procedure, before operate software shut down function please note the essence install our software on as
following :
1. Please install program “ IP9258service.exe “ in controlled PC.
2. If there is operate program like WINDOWS OFFICE which can not be save automatically.
9258 will still shut down controlled PC/server without save the file.
3. To reserve enough time for controlled PC / Server shut down after receive 9258 command.
Please set the delay time at 30 or 60 second in 9258 web page( setup delay switch ).
4. The controlled PC /Server must be in the same ETHERNET and the same SUBNET.
- 10 -