User Guide

- 10-
Ref#9076101012
4.) Hardware Setup
*Before setup the device make sure of the following:
1.) Make sure that all the package contents are all included
if anything is missing please contact the store or your distributor.
2.) Make sure the power adaptor is the correct specification.
3.) Make sure that all the cables are working correctly
Connecting the Device
1.) Connect the IP Kamera 9076 to a HUB or Router with a RJ45 network cable.
2.) Connect the HUB or Router to the internet (May through ADSL/XDSL modem).
3.) Connect the power adapter to the DC 5V port of IP Kamera 9076.
Focusing the IP Kamera
To focus or adjust the lens of the IP Kamera you will need to remove the covering to get to the lens part of
the 9076. To do this, follow these steps below.
1.) Carefully remove the outer clear plastic shell by turning the lid counter clockwise.
2.) Then carefully remove the inner casing by prying the left and right sides gently outwards and lifting up.
3.) To focus the lens by use the two knobs that are on the lens. If the lens does not turn slightly turn the
knobs in a counter clockwise direction to loosen the knob. The front knob controls the distance of the
lens while the back knob is used to adjust the focus.