User manual

Ex. http command
http://192.168.1.192/vb.htm?subnetmask=255.255.0.0
Note: Default subnet mask is 255.255.0.0
Change Gateway:
This command changes the gateway the IP Kamera 9070-IR.
http://ipaddress:port/vb.htm?gateway=gatewayaddress
Ex. http command
http://192.168.1.192/vb.htm?gateway=192.168.1.1
Change DNS:
This command changes the gateway the IP Kamera 9070-IR.
http://ipaddress:port/vb.htm?dnsip=dnsipaddress
Ex. http command
http://192.168.1.192/vb.htm?dnsip=168.95.1.1
MJPEG Streaming
This command integrates streaming data into a software, website, or any other application.
http://ipaddress:port/ipcam/mjpeg.cgi
Ex. http command
http://192.168.1.192/ipcam/mjpeg.cgi
8.) Using RTSP with VLC
Before Setting up VLC: Make sure that the 9070-Lite is set to be the DMZ host on the
router that you are using, please refer to the routers manual on how to accomplish this.
How to setup VLC media player & Open a network stream
Note: Before using RSTP you must port forward your router to the following port numbers.
For 1280 x 720P (Mpeg4-1): Port forward to 554
If Port forwarding (Mpeg4-2): Port forward to 8554
1.) Open VLC media Player
2.) Click on Tools > Preference
3.) On the bottom of the screen click the Reset preference button.
4.) On the bottom left hand side of VLC select the all under the show settings area.
5.) Then in the left panel select Input / Codecs > Demuxers > RTP/RTSPl and type in the RTSP user
name and RTSP password.
- 46-
Ref#90020326K0709