User manual

How to Enable and Use EPTZ Controller
Note: When EPTZ is activated Video Codec mode will be switched to MPEG4 & M-Jpeg when disabled the
codec will be set on Mpeg1, Mpeg2, & M-Jpeg.
Also snapshot function works only with the EPTZ controller and not when using the mouse to EPTZ.
1.) Click on the EPTZ button located on the bottom of the screen of the 9070.
2.) If the EPTZ has not been enabled you will be notified that it must be enabled.
3.) Select Enable on the EPTZ function then hit the submit button
.
Once the Speed dome controller is activated you can click on left, right, up, down, and zoom buttons to view
the picture.
Note: To use EPTZ without activating
7.) Controlling the Device
CGI HTTP Commands
Http commands allow you to control the device with commands. The basic commands are provided below.
There are two ways to input http commands with authorization required
Password in http:
http://login:password@ipaddress:port/command
Password not in http:
http://ipaddress:port/command
Note: If you use the password not in http: command you will need to enter it when the browser asks
for the password.
Snapshot Command:
The snapshot command takes a snapshot of the camera in the current view.
http://ipaddress:port/snapshot.cgi
Ex. http command:
http://192.168.100.50:85/snapshot.cgi
- 45-
Ref#90020326K0709