User manual

Enable Alarm – Lost Ethernet Connection: Save into SD Card:
When Ethernet connection is lost the device will automatically save into the SD card. Saving a backup.
Enable Alarm - Upload
FTP
When motion is detected, the IP Kamera 9070 will upload the video file to the selected FTP server.
Enable Alarm - Save Into
SD Card
When motion is detected, the IP Kamera 9070 will upload the video file to the SD card.
Enable Alarm – Save
SMTP
When motion is detected, the IP Kamera 9070 will send the video file to in a E-mail format.
Recording Time: Set the duration of time you would like the IP Kamera 9070 to record when alarm is set off.
Enable Alarm Recording Buffer: The alarm recording buffer allows the camera to the selected amount of
buffer time before an alarm has been detected. This allows the IP Kamera 9070 to start recording before any
incident has occurred.
EPTZ-Set
The EPTZ allows you to Pan, Tilt, & Zoom the image that you are viewing.
To activate this feature EPTZ must be enabled in the Image section of the 9070.
Note: When EPTZ Controller is activated Video Codec mode will be switched to MPEG4 & M-Jpeg when disabled the
codec will be set on Mpeg1, Mpeg2, & M-Jpeg.
How to use EPTZ with the mouse
On the Live view Video screen the EPTZ controls are:
Zoom In: Click and Hold the left mouse in the live view then release when zoomed to preferred point
Zoom into highest: Double click left mouse
Zoom out: Click and Hold the right mouse in the live view then release when zoomed to preferred point
Zoom out to screen fit: Double click right mouse
Note: When using the mouse to zoom in the snapshot function will not take a picture of the zoomed picture
but the resolution size.
- 44-
Ref#90020326K0709