User manual

- 22-
Ref#90020326K0709
Now the device is connected to the wireless network.
Unplug the Ethernet cable to the device.
Then unplug the power cable to the device for about 15 seconds.
Then plug in the power to the device and give the device about 1 minute to start up. Then
with IP Edit search for the new wireless device. If the device is using wireless, you
should see a (w) next to the name of your device.
See example below:
Note: Remember to Port forward the device with the New Wireless IP Address so that
you can connect to the device from via outside the network.
IP Service
How to use IP Service on IP Edit:
IP service allows the user to directly connect to his / her device through the internet without having to
remember long confusing IP Address. Instead you only need to remember the name of the device that the
you have selected. Then the user can connect to IP Service, type in the device name, and connect directly
to the device.
Note: IP Kamera 9070-IRW requires you to select Server 2 on IP Service
1.) Open IP Edit, the device will show up in the Local Device Section. If you have not selected a name
for the device, please refer to the section on the manual labeled: ―Naming your device‖.
2.) To start IP Service, Press the green connect button on the top of IP Edit.
3.) Once you have been connected search for your device by typing in at least the first 3 letters that you
named your device with. Then hit the search button.