User Manual

8. We recommend you seal the slot between the wing panels using the supplied plastic strips.

If your choice is the ETO, then you can glue the air scoop on, if you have the Desert version

please glue the two pieces of the volks filter in to place (be sure not to glue the rear and the front

filter part together), then secure the cowl using (2.3x10) screw.

9. Glue into place the fish tail and the exhaust stacks , the fuselage aerial and the rear view mirror.

3x25mm

3x32mm

10. Install your choice of 6ch receiver ensuring all the wires are clear and held away from the servo

horns. The chosen battery should be fitted into the battery compartment as far forward as possible to

achieve the correct C of G as shown on Page 10.

11. Assemble the propeller as shown using the supplied 3x25mm screws, pull these screws up

evenly. Once assembled slide the spinner backplate and prop assembly onto the motor shaft, make

sure the hex cutout at the rear fits over the hex at the base of the shaft. Then fit the prop nut and

tighten firmly, finally fit the spinner using the supplied 3x32mm screw.