User Manual

ASSEMBLY

1. Out of the box your Spitfire comes with a reinforced foam hinge for the elevator. However before

assmbly can begin, the hinge line must be flexed back and forth 5-6 times to reduce the tension

and the load on the servo.

2. Insert one half of the carbon tail spar into the starboard horizontal tail (A)

. Before sliding this

into the tail slot of the fuselage, be sure to insert the elevator joiner into the driving unit which will

drive both elevators. Now install the remaining port side of the tail (B). Secure both halves with

the supplied 2.3x6mm screws and the elevator joiner(2.3x6), This installation is self aligning, but

do double check to ensure equal alignment to the vertical tail and the wing.