KingTwin 1700 (PNF) Full Instruction Manual

3. Install the vertical fin onto the fuselage. Ensure it is fully seated, and the front part of the vertical fin

is fully inserted into the slot as shown. Use the supplied set of 3 x 8mm self-tapping screws to lock

the vertical fin in place.

Note: Please do this on both sides.

4. Trial fit the stabilizer onto the fuselage and ensure it is fully seated inside the slot. If you are

satisfied with the fit apply foam safe glue to the slot and the wooden spar on the stabilizer, then

install

it onto the fuselage as shown. In this meantime, repeat this step to install the stabilizer on

the other side. Ensure the stabilizer on both sides stay level whilst the glue dries.