(PNF) C-130 V2 Civilian & US Coast Guard Full Instruction Manual

12.Double check to ensure all the flap control surfaces are operating in the same manner.
13.Pics #1-3 below shows the inboard and outboard flaps when fully deployed.
Pic #1 Pic #2 Pic #3
CARGO BAY DOOR SETTING PROCEDURE:
1.Switch on your radio. You can either assign a 2 way or a 3 way switch to a free channel to
operate the cargo bay door.
2.Then go into the end points set up page.
3.Adjust both end points to approximately 30% of the total travel on either side.
4.Plug the cargo bay servo lead ( brake) into the selected channel on the receiver.
5.Leave the cargo bay door half open and power up the receiver.
6.The door should not move too much if the end points have been adjusted correctly.
12