User Manual

10. Repeat the above setup from #7 to #9.
11 . You may also adjust the ball socket on the linkages to ensure all the flap control
surfaces retract and deploy evenly.
Plug in the UBEC cables to the power cables on the plane. Pay attention to the
polarity and ensure that all the pins are fully seated into the socket.
See pic #1 and #2.
12. Finally check again to ensure all the flap control surfaces are operating in the
same manner.
13. Pic #3 below shows the inboard and outboard flaps when fully deployed.
Figure 1
Figure 2
11