c130-manual

Pic #1

Pic #2

Pic #3

10. Repeat the above setup from #7 to #9.

11 . You may also adjust the ball socket on the linkages to ensure all the flap control

surfaces retract and deploy evenly.

Cargo bay door setting procedure:

1. Switch on your radio. You can either assign a two way switch or a three way

switch to a free channel to operate the cargo bay door.

2. Then go into the end points setup page.

3. Adjust both end points to approximately 30% of the total travel on either side.

4. Plug the cargo bay servo lead ( brake) into the selected channel on the receiver.

5. Leave the cargo bay door half open and power up the receiver.

6. The door should not move too much if the end points have been adjusted

correctly.

For a two way switch setup

1. Adjust the end point so that with the switch position selecting the door closed

and the door is flushed with the fuselage and there is no buzzing from the servo.

2. Flick the switch to the door down position and adjust the end point so that the

door just misses the ground.

For a three way switch setup

1. Flick the switch to the door up position and adjust the end point value until it is

flushed with the fuselage and there is no buzzing from the servo.

2. Flick the switch to the door halfway open position and adjust the end point value

so that the door is levelled to the fuselage main axis.

3. Flick the switch to the door down position and adjust the end point value so that

the door just misses the ground.

12. Finally check again to ensure all the flap control surfaces are operating in the

same manner.

13. Pic #3 below shows the inboard and outboard flaps when fully deployed.