User Manual

62A-16R Pe R s o n A l Mi x e R A n d A-16Cs Co n t R o l su R f A C e us e R Gu i d e
Problem: Can’t change Presets
Possible Solutions:
Make sure that the • Re c a l l button has been pressed. Its LED
will flash, indicating that you should press a numbered
button to recall a Preset.
Problem: I don’t think my Preset was saved.
Possible Solutions:
When saving a Preset, make sure that the • Re c a l l and GR o u p
buttons are both held down before pressing one of the
numbered memory location button. The Preset is saved
when you release your finger from the memory location
button. When a Preset has been saved correctly, you will
see all sixteen channel LEDs flash momentarily to confirm
the save operation.
Problem: Can’t hear a channel that is part of a Group
Possible Solutions:
The Group might be muted. Check the lower (yellow) LED •
in the channel buttons. A lit yellow LED indicates the chan‑
nel is muted. To unmute it, press the mu t e button while the
Group is selected. The yellow LED must be unlit in order to
hear the audio on that channel.
The channel volume is all the way down. In Group edit •
mode, select the channel and check the level for that chan‑
nel by looking at the LEDs in the Volume indicator. If no
LEDs are lit, then the channel is turned all the way down.
Raise the volume by turning the channel Vo l u m e knob;
re‑save the Group and Preset if necessary.