User Manual

44A-16R Pe R s o n A l Mi x e R A n d A-16Cs Co n t R o l su R f A C e us e R Gu i d e
Changing Channel Settings
When the A‑16CS Control Surface is used to control an A‑16R remotely, all
edits made on the A‑16CS will be reflected immediately on the A‑16R. When
you change the volume of a Channel from the A‑16CS, the LEDs in the Volume
section of the Personal Mixer and A‑16CS will move simultaneously and will
indicate the level changes in real time.
Saving a Mix From the A-16CS
When creating monitor mixes, you can save your work as a Preset remotely
from the A‑16CS. The Preset itself is stored in inside the A‑16R, not in the
A‑16CS. This ensures that the mixes you create are always available in
the device that is controlling the audio. Also, you can move the A‑16CS to
another A‑16R for remote creation of mixes and Presets without losing any
mix information in the original A‑16R.
To Save a mix as a Preset:
Create your mix by setting volume, pan, mutes, and groups •
as desired.
On the A‑16CS hold down the • Re c a l l and GR o u p buttons
simultaneously.
While still holding both buttons, press any numbered •
channel button.
The numbered channel buttons flash to indicate that the •
Preset is stored.
Recalling a Preset From the A-16CS
As mentioned previously, your mixes are stored as Presets inside the A‑16R.
You can recall a mix Preset remotely from the A‑16CS. Or, if the A‑16CS is not
available, the same Presets can be recalled from the front panel of the A‑16R.
To recall a Preset from the A‑16CS:
Press the • Re c a l l button.
The • Re c a l l button will flash.
Select a numbered channel button (1 to 16) corresponding •
to the Preset mix that you want to recall.
When the channel button is pressed, the mix is recalled •
and is now available and can be edited if desired.
When a Preset is selected from the A‑16CS remote control, the same
numbered LED on the front panel of the A‑16R will flash briefly to indicate
that the preset has been loaded.