User Manual

9A-16R Pe R s o n A l Mi x e R A n d A-16Cs Co n t R o l su R f A C e us e R Gu i d e
Type: Switching
Input Voltage: 90‑240 volts 50/60Hz 30VA
Output: 24VDC 0.5A
Polarity Outer = negative; Inner = positive
Plug Size 2 mm
_
+
Power Supply Polarity
Note that polarity of the plug found on the DC power supply needs to match
that of the original power supply that came with your Aviom equipment.
Aviom products use a center positive power supply. The outer contact is
negative, the inner contact is positive. (See the diagram above.)
Cleaning and Maintenance
The exterior of your Aviom products should be cleaned with a dry, soft, lint‑
free cloth. For tougher dirt, you can use a cloth slightly dampened with water
or with a mild detergent.
When cleaning your Aviom products, never spray cleaners directly onto the
product surfaces. Instead, spray a small amount of the cleaning solution onto
a clean cloth first. Then use the dampened cloth to clean the product.
P No t e : Never use solvents or abrasive cleaners on the finished surfaces of
your Aviom products.
Installing the A-16R in a Rack
The A‑16R Personal Mixer is designed to be installed in a standard 19‑inch
audio equipment rack. This design is both for easy transportation of the
units and for protection in a permanent installation. Each unit takes up one
standard rack space (19 inches wide by 1.75 inches high). Optionally, you can
place the units on a table top or other flat surface such as a shelf.
The rack ears on each side of the device are designed to support the weight
of the A‑16R without additional hardware. Each rack ear contains holes for
two screws per side. Always support the unit with all four screws.