User guide

15
A-16D Pro A-Net Distributor User Guid
e
Mixer in your system.
•
DC power is supplied automatically to the first connected
Personal Mixer - no external DC power supply is required.
At this point the Personal Mixer is connected to the A-Net signal chain.
Any audio connected to the A-Net input module should be available for
mixing in the Personal Mixer. Refer to the Personal Mixer User Guide for
additional information about using the mixing features of the Personal
Monitor Mixing System.
Connect additional Personal Mixers using Category 5 cables from an
available Output on the A-16D Pro A-Net Distributor to the A-Net Input on
the Mixer.
The A-Net outputs on the A-16D Pro can be connected to any A-Net
compatible device, allowing flexible routing and system configurations as
well as virtually unlimited system expansion.
Connections on the
A-16D Pro
Rear
Panel
The rear of the A-16D Pro A-Net Distributor contains the standard IEC
power input for the unit. The main power supply in the A-16D Pro is a
switching type, compatible with the variety of electrical systems in use
worldwide.
The A-16D Pro can operate with input voltages from 100 to 240 volts and
at rates from 50 to 60 Hz. Replaceable IEC cables for AC power systems
throughout the world are available from many electronics dealers. Avoid
using cable adapters whenever possible. Replacement cables must provide
an earth ground connection.
Powering a Personal Mixer Remotely
There are a number of advantages to adding power for a Personal Mixer at
the A-Net distribution point.