User`s manual

E-6
Safety Precautions
• Donotdothefollowings
• Donotputanythingheavyontheprojector.
• Donotstepontheprojector,rack,orstand.Donotholdorhangontheprojector.
Doing so could cause the projector to roll over or break, resulting in injury.
Especially be careful if small children are near.
• Donotusetherackunlessthecastersarelockedwhenplacingtheprojectoronarackwithcasters.
Doing so may cause the projector to move or roll over, resulting in injury.
• Donotturnthelampon/offwithinoneminuteafteritisturnedoff/on.Extremelyhighvoltageisgeneratedinthelampjust
after it is turned on. Turning the lamp on/off too frequently could cause the lamp to deteriorate or break, resulting in mal-
functions of the projector.
• Donotprojectanimagewiththelenscapattached.
• Donotusewiththeairlterremoved.Doingsocouldcausedamageormalfunction.
• Donotlifttheprojectorbygraspingthefocusadjustmentring.Doingsowillcauseafaultordamage.
• Afterdisconnectingthepowercablefromtheprojector,allowanintervalofatleast5secondsbeforeinsertingitagain.
• Movingtheprojector
Theunitismeanttobeusedinastationaryposition.
• Besurecarefuloftheglasssurfaceatmovingtheprojectorwhileholdingthehandles.
• Ifthedocumentcoverisnotinsertedenough,itmaygetlooseandfalloffwhileyoucarryit.
• Avoidswingingitaroundortreatingitroughly.
• Careofthepowercableandplug
• Donotputthepowercablenearaheater.
Doing so could cause the sheath of the cable to melt down, resulting in re or electric shock.
• Donotconnectordisconnectthepowercablewithwethands.Doingsocouldcauseelectricshock.
Onlyusetheincludedpowercord.
• Onlyusethepowercordincludedwiththeprojector.Usingotherpowercordscouldresultinreorelectricshock.
• Besuretoestablishagroundconnection.Thegroundconnectionmustbemadebeforepluggingthepowercableintothe
outlet.
Connect or insert the ground wire to a ground terminal only; do not connect it elsewhere.
• Besuretopulloutthepowercableanddisconnectanycableconnectionsbetweenunitsandreleasetheanti-theftlock
before moving the projector.
Moving the projector with cables connected may cause re or electric shock if the cables are damaged.
• DONOTREMOVEANYSCREWSexceptthelampcoverscrewandtwolampunitscrews.Otherwiseyoucouldreceive
anelectricshock.
• Abouttheprojectionlampandotheropticalparts
Optical parts such as the light source lamp, fan, and color wheel are parts that require periodic replacement (i.e., periodic
replacement parts).
When the projector is used continuously for long periods (of 5 or more hours daily), the replacement of those parts may
even become necessary in less than one year of use.
Note also that use of the projector in places where there is tobacco smoke or a lot of dust may shorten the replacement
cycle of the periodic replacement parts. Please inquire with the dealer for details.
• Keepyourfaceawayfromtheexhaustvents.
• Ifthelampisbroken,dustmayenteryoureyesormouth.Besuretokeepyourfaceawayfromtheexhaustvents.Other-
wise, it may result injury.
(If foreign matters enter the eyes, consult an ophthalmologist.)
Downloaded From projector-manual.com Avio Manuals