User`s manual

E-13
A Check of the Supplied Items and the Names of the Parts
Names and Functions of the Parts (Operation Panel)
1. ON/STANDBYLED
Lit red during standby and lit green when the projection
lamp is on. See Page E-23.
2. LAMP/COVERLED
Lit green during projection. Lit red when the air lter or lamp
unit cover is not in place.
• Atthetimeoftheprojectionlamplightingoperation,the
LEDashesforabout6secondsandthenlightsgreen.
• Atthetimeofaprojectionlamplightingfailure,theLED
ashesgreen.(Theashingintervalwhentheprojection
lampisoffwillbelongerthanwhentheLEDashesat
other times.)
• Whentheprojectionlampisoff,theLEDashesgreen
for 60 seconds and then goes off.
• Whenthe projection lamp has been used in excess of
1,900 hours, the LED flashes red; when use exceeds
2,000 hours the LED is lit a steady red.
See Page E-44.
3. TEMPLED
When the internal temperature has risen excessively, the
LED flashes red for 10 seconds, then is lit a steady red.
See Page E-44.
LED List
LED State
Significance
ON/
STANDBY
LAMP/
COVER
TEMP
Off Off Off AC power OFF
Normal
condition
Red Off Off Standby
Green
Flashing
green
Off
Standby to start of projec-
tion
End of projection to
standby
Green Green Off Projecting
Red Red Off
Lamp cover open
Power
has been
switched
OFF
because of
the alarm
Lamp burned out
Red
Flashing
red
Off
Lamp usage exceeds
2,000 hours
Red Orange Off Internal problem
Red Off Red
Temperature fault
Fan fault
Green
Flashing
red
Off
Lamp usage exceeds
1,900 hours
Alarm
sounding
Green Green
Flashing
red
Abnormal temperature
warning
4. ON/STANDBYButton
Switches the power of the projector on or off (standby
mode).
* Only this button is effective when the projection lamp is
off.
See Page E-23.
5. INPUTButton
Press this to switch the input.
 The input switches as follows: OHP → PC → VIDEO or
OHP → VIDEO (D4) → VIDEO.
See page E-25.
6. PORTRAITButton
 WhenOHPisselected:Changestheorientationofthepro-
jection image to 0° and to 90°. (The projected image can
be rotated 360° in 90° steps from the menu.)
See Page E-25.
7. FREEZEOFFButton
Cancels the still image mode.
Cancels the still image mode.
This is used when checking the projection screen while
moving the document.
See Page E-29.
8. FREEZE/CAPTUREButton
Makes the projection screen image into a still image.
When OHP is selected, the still image is stored in the inter-
nal memory or in the USB memory as a history image.
See Page E-28.
ON/STANDBY
LAMP/COVER
TEMP
FREEZE OFF
FREEZE/CAPTURE
PORTRAIT
INPUT
1 2
3 4 5 6 7 8
Downloaded From projector-manual.com Avio Manuals