Owner's manual

Avigilon Control Center System Integration Guide with S2 NetBox
4
Configuring Avigilon Control Center in the S2 NetBox
Your S2 NetBox web client should display Setup > Cameras > Configure Avigilon NVR in the
Table of Contents. Open the Configure Avigilon NVR page and configure the S2 NetBox to
connect with the Avigilon Control Center Server.
1. Enter the IP address to your Avigilon Control Center Server.
2. Enter an Avigilon Control Center server port that is free for communicating with the S2
NetBox Server.
The default port number is 8080.
3. Enter the Avigilon username and password you created for the integration. See Adding
an Integration User in Avigilon on page 3.
4. Click Check connection.
You have made a successful connection when the following message appears:
This Avigilon NVR can be configured for network controller integration.
If you receive an error message instead, check if your firewall is blocking the
connection.
5. Click Save.
NOTE: Whenever you make changes to the Avigilon Control Center camera connections, you
need to update the Avigilon NVR configuration in the S2 NetBox software.
To update the integration, access the Configure Avigilon NVR page and click Check Connection
to download the updated camera connections then click Save.