Installation guide

Rear View
1. Camera Mounts
Provides mounting points for the camera. Mounts accept 1/4”-20 UNC bolts commonly found on tripods
and mounting brackets.
2. SD Card Slot
Accepts an SD card for onboard storage.
3. Power Connector Block
Accepts a terminal block with either an AC or DC power connection. DC input can be either polarity. Only
required when Power over Ethernet is not available.
4. Ethernet Port
Accepts an Ethernet connection to a network. Server communication and image data transmission occurs
over this connection. Also receives power when it is connected to a network that provides Power over
Ethernet.
5. Link LED
Indicates if there is an active connection in the Ethernet port.
6. Connection Status LED
2 Rear View