Installation guide
1. Insert an SD card into the camera.
CAUTION — Do not force the SD card into the camera or you may damage the card and the
camera. The SD card can only be inserted in the orientation shown on the camera.
2. Access the camera’s web interface to enable the onboard storage feature. For more information, see the
Avigilon High Definition H.264 Camera Web Interface User Guide.
Installing the Dome Cover
1. Rotate the black shield located inside the dome bubble so that it does not block the camera’s field of
view.
Skip this step if you are installing a dome camera with IR illumination.
2. Attach the dome cover to the base by tightening the screws with the provided Torx key.
3. Be especially careful not to mark the dome bubble or the contaminants will cause unwanted reflections in
the -IR model.
4. Remove the plastic cover on the dome bubble.
Focusing the DomeCamera
NOTE: Ensure this procedure is performed after the dome cover is installed, so the focus shift caused by the
dome bubble’s refraction can be accomodated.
l In the Camera Installation Tool or camera web browser interface, use the camera’s Image and Display
settings to focus the camera lens.
a. Click the Auto Focus button to focus the lens.
b. If the desired focus was not achieved, use the focus near and far buttons to adjust the focus.
CAUTION — Do not attempt to adjust the focus and zoom on the camera manually or the camera lens
may become damaged
For More Information
Additional information about setting up and using the device is available in the following guides:
l Avigilon Camera Installation Tool User Guide
l Avigilon Control Center Client User Guide
l Avigilon High Definition H.264 Web Interface User Guide
The manuals are available on the Avigilon website: http://avigilon.com/support-and-downloads
11 Installing the Dome Cover